Difficulty: 1/5
You will need:
- 13mm spanner or socket/ratchet.
- Pliers.
- Remove the two bolts holding the calliper to the calliper-hanger using a 13mm spanner or socket.
- Slide the calliper off the brake-disc.
- Remove the two R-clips from the pin at the bottom edge of the calliper that holds the pads in and slide the pin out.
- Remove the old brake-pads.
- Using the end of pliers or another blunt object to push the piston(s) as far back into the calliper as they will go.
- Insert the new brake-pads.
- Slide the pin back in through the holes in the new brake-pads and replace the R-clips.
- Slide the calliper back over the brake-disc and replace the two 13mm bolts.
 |
| Tidy Brembo 2-pot callipers. |
 |
| Tidy EBC Red-Stuff pads are dope, but take a while to warm up. |
 |
| Tidy job. |
